NVIP-4DN3515V/IR-1P - User’s manual (short form) ver 1.0.
All rights reserved © AAT Holding S.A.
10
Information:
Power supply adapter is not included. Please use power adapter with parameters specified in user’s
manual.
Caution:
In order to provide protection against voltage surges/lightning strikes, usage of appropriate surge
protectors is advised. Any damages resulting from surges are not eligible for service repairs.
It is forbidden to use – as the camera power source – PoE equipment (adapters, etc.) not compatible
with IEEE 802.3af standard (items called “passive PoE power supply”). Damages that results from the
usage of improper power supply source are not covered by the warranty
2.4. Camera mounting
1.
Remove locking screw from camera base and then remove camera base.
2.
Put base of the camera to the desired mounting surface, and mark drilling holes using base as a
template.
3.
Drill mounting and cable holes in previously selected points.
4.
Mount the camera base using included screws on smooth surface providing declared degree of IP
protection.
5.
Mount camera to camera base and screw locking screw.
6.
Use the included allen key to remove the camera cover dome screws and remove cover dome.
7.
Adjust the position of the camera module. If required, loosen the screws blocking camera
module.
8.
Put on the camera cover again, matching screws to the corresponding holes located in the base
of the camera and screwing until slight resistance is felt. Please ensure that the mask doesn’t
block camera’s field of view.
START-UP AND INITIAL IP CAMERA CONFIGURATION
