NVIP
-
5VE
-
4201
Quick start guide
ver. 1.1
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA sp. z o.o.
9
2.3.
Camera mounting
To mount a camera please follow the instructions below:
•
Remove the retaining ring (A) by turning it counter
-
clockwise
•
Remove the camera cover (B), remove the camera from the base
•
Put the bracket to the wall in a desired mounting place (with cable hole). Taking the bracket
’
s
base screw holes as a pattern, mark future drilling holes for screws.
•
Drill holes in accordance with previously done markings and base hole placement.
•
Mount the camera base using the supplied plugs and screws.
•
Connect the camera cables, put camera on the base, attach the cover (B) and pre
-
tighten the
retaining ring (A)
•
Adjust camera position.
•
Tighten to the stop retaining ring (A)
WARNING!
Please note that the wall or ceiling must have enough strength to support the IP Camera.
WARNING!
In order to obtain declared degree of protection please seal the camera bracket to prevent water
getting inside. Furthermore, when installing the bracket on rough/uneven surfaces, please
additionally seal the junction with appropriate sealing mass. Please pay special attention to any
mounting holes and if they are a loop
-
through ones, seal them too.
WARNING!
The declared degree of protection of the camera relates to its housing and does not take into
account the possibility of moisture infiltration into the interior of the camera by connecting
cables. Connection cables protection through i.e. sealing up is the responsibility of the camera
installer. The manufacturer is not liable for any damages to the camera caused as a result of
failing in performing that activity by installer, which also means that camera damaged in that
way is not subject to warranty repairs.
START
-
UP AND INITIAL IP CAMERA CONFIGURATION
A
B
