NVIP
-
5H
-
4402/F
Quick start guide
ver 1.1
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o.
9
START
-
UP AND INITIAL IP CAMERA CONFIGURATION
2.2.
Power supply connection
When powering the camcorder from an external 12VDC power supply, make sure it has the correct
settings and that the power supply connector has the correct polarity. Using an incorrect power supply
may result in malfunction or damage.
The camera can also be powered via an RJ45 network connector, using PoE (IEEE 802.3af)
technology. Please, use a network switch or an IEEE 802.3af compliant PoE power supply to power
the camera through the PoE.
CAUTION!
It is forbidden to use –
as the camera power source –
PoE equipment (adapters, etc.) not compatible with
IEEE 802.3af standard (items called
“
passive PoE power supply
”).
Damages that results from the usage
of improper power supply source are not covered by the warranty.
2.3. Connecting ethernet cable
To maintain tightness of ethernet cable connection, please follow instruction below:
1. Unscrew the nut (b) from the connector cover (a), mount the sealing ring on the socket (c)
2. Route the network cable through the components (a) and (b). Plug the RJ
-
45 connector into the
socket (c)
3. Screw the connector cover (a) on the socket (c). Inside the upper part of the connector cover (a)
push in to the stop the seal of the cable (d)
-
the seal is cut to insert on the network cable.
4. Tighten up to the stop nut (b)
WARNING!
Other connectors and sockets, outside of the RJ
-
45 socket, are not hermetically sealed. User
should seal this connector by himself.
b
a
b
a
c
d
Center pin +12V
GND
