NVIP-4DN3513H/IR-1P - User’s manual (short form) ver 1.1
All rights reserved © AAT Holding S.A.
9
1. SD card slot
2. Network indicator
3. 3 pin connector. Video output and power supply - maintenance only
4. Reset button
WARNING!
To get access to above ports it is required to open front cover
WARNING!
In order to obtain declared degree of protection please seal the camera bracket to prevent
water getting inside. Furthermore, when installing the bracket on rough/uneven surfaces, please
additionally seal the junction with appropriate sealing mass. Please pay special attention to any
mounting holes and if they are a loop-through ones, seal them too.
2.2.
Cameras mounting
To mount a camera please follow the instructions below:
1. Drill the screw holes and the cable hole on the wall according to the drill template.
2. Route the cables to the cable hole and connect the cables.
3. Using included screws mounting base on smooth surface providing declared degree of IP protection.
4. Optionally open service compartment to insert SD card and connect monitor through DCIN/CVBS
cables.
5. Using allen key loosen screws 1, 2 and 3. Then adjust camera position and tight lock screws.
WARNING!
Please note that the wall or ceiling must have enough strength to support the IP Camera.
3.
START-UP AND INITIAL CAMERA CONFIGURATION
1
2
3
