NVIP-3DN7540H/IRH-
2P User’s manual ver.1.0 (short form)
All rights reserved © AAT Holding sp. z o.o.
9
2.2. Camera mounting
To mount a camera please follow the instructions below:
Put the bracket to the wall in a desired mounting place (with cable hole). Taking the bracket’s
base screw holes as a pattern, mark future drilling holes for screws using a punch.
Drill holes in accordance with previously done markings and base hole placement.
Mount the camera with bracket on the ceiling/wall with three supplied self tapping screws.
Adjust the camera vertical position using the
“A”
screws.
Adjust camera position loosening the horizontal adjustment screw (
“B”
screws).
Adjust camera rotation loosening the adjustment screw (
“C”
screws).
CAUTION!
Please note that the wall or ceiling must have enough strength to support the IP Camera.
CAUTION!
In order to obtain declared degree of protection please seal the camera bracket to prevent water
getting inside. Furthermore, when installing the bracket on rough/uneven surfaces, please
additionally seal the junction with appropriate sealing mass. Please pay special attention to any
mounting holes and if they are a loop-through ones, seal them too.
START-UP AND INITIAL CAMERA CONFIGURATION
E
A
B
C
D
