NVIP-3DN5030SD/IRH-2 User’s manual (short form) ver.1.0
All rights reserved © AAT Holding S.A.
11
2.2. Mounting the camera
In order to obtain declared degree of protection please seal the mounting place additionally with
appropriate sealing mass, paying special attention to mounting holes.
Declared degree of protection of the camera concerns to it case and does not include the possibility
penetration of moisture through connecting cables. Securing cables is a responsibility of person who
install the camera. The manufacturer is not responsible for any injury, damage of the camera caused by
any failure above-mentioned duty, what also means they are not subject to warranty repairs.
CAUTION!
Due to safety reasons, maximum load capacity of surface shouldn’t be less than 25kg.
In order to successfully mount a camera, please follow the procedure below:
Put the bracket to the wall in a desired mounting place (with cable hole). Taking the bracket’s
base screw holes as a pattern, mark future drilling holes for screws using a punch.
Drill 4 holes in accordance with previously done markings, insert the expansion plugs into the
holes.
Thread the wires through the hole in the wall bracket.
Attach the camera to the bracket and rotate the camera clockwise to align screw holes on the
installing base of the camera and the bracket.
Then tighten the three screws to fix the bracket and camera.
By using the description of the terminals from the previous chapter and the appropriate
accessories, connect required signal and power supply cables.
CAUTION!
Connection the power cable to the camera must be performed after disconnecting the power
source. Power can be on only after the camera is fully mounted.
Put the excess cable back into the bracket.
Screw on the camera with the bracket to the wall.
After the above steps the camera is ready to work
START-UP AND INITIAL CAMERA CONFIGURATION
