NVIP-3DN3012V/IR-1P, NVIP-3DN3013V/IR-1P, NVIP-3DN3014V/IR-1P - User’s manual
(short form) ver 1.0
All rights reserved © AAT Holding sp. z o.o.
13
NVIP-3DN3014V/IR-1P
1.
Remove locking screw from camera base and then remove camera base.
2.
Use the included mounting template or the camera base plate to mark holes for mounting
screws.
3.
Drill mounting and cable holes in previously selected points.
4.
Mount the camera base using included screws on smooth surface providing declared degree of
IP protection.
5.
Mount camera to camera base and screw locking screw.
6.
Use the included allen key to remove the camera cover dome screws and remove cover dome.
7.
Adjust the position of the camera module. If required, loosen the screws blocking camera
module.
8.
Start camera and adjust focal length and focus using proper levers.
9.
Put on the camera cover again, matching screws to the corresponding holes located in the base
of the camera and screwing until slight resistance is felt. Please ensure that the mask doesn’t
block camera’s field of view.
START-UP AND INITIAL CAMERA CONFIGURATION
