NVIP-4DN7000C-1P User’s manual (short form) ver.1.0
All rights reserved © AAT Holding S.A.
11
NVIP-4DN7000C-1P User’s manual (short form) ver.1.0
2.3. Starting the IP camera
To run NOVUS IP camera you have to connect ethernet cable between camera and network switch
with PoE support (IEEE 802.3af).
You can also power it directly via power supply adapter with parameters compatible with camera
power supply specification.
After connecting power supply power indicator (green LED) should light on, also the green LED on the
RJ45 connector, indicating a successful connection to a network switch, will be lit. If the connection is
successfully established, orange LED blinks with a frequency proportional to the quantity of data flow.
Initialization process takes about 30 seconds. You can then proceed to connect to the camera via web
browser. If connection isn’t established (the network cable is disconnected) green and orange LEDs
aren't active, solid orange light means that network connection is ok but camera doesn't receive or send
any data, with possible PC network settings error.
The recommended way to start an IP camera and perform its configuration is a connection directly to
the network switch which is not connected to other devices. To obtain further information about
network configuration parameters (IP address, gateway, network mask, etc.) please contact your
network administrator.
Connection utilising network switch with PoE support
Connection utilising external power supply and network switch
START-UP AND INITIAL CAMERA CONFIGURATION
Computer
IP camera
Power supply and data
transmission
Data transmission
PoE Network switch
IP camera
Data transmission
Data transmission
Network switch
Computer
Power supply
Orange LED
Green LED
