NVIP-2DN5000V/IR-1P, NVIP-3DN5000V/IR-1P, NVIP-2DN5020V/IR-1P User’s manual
(short form) ver.1.1
All rights reserved © AAT Holding sp. z o.o.
11
2.2. Camera mounting
Cameras NVIP-2DN5000V/IR-1P, NVIP-3DN5000V/IR-1P
1. Use the included allen key to remove the camera cover screws (2x). Lift the cover
away from the camera.
2. Use the included mounting template or the camera to mark holes for the mounting screws.
3. Mount the camera to the surface using the included mounting screws (2x).
4. If you need to adjust the viewing angle, loosen the screws on the sides of the ball camera and adjust
the ball camera. Do not remove the screws holding the ball camera. Tighten the screws when finished.
5. Ensure the rubber gasket inside the camera is properly in place, then replace the camera cover and
the camera cover screws (2x).
START-UP AND INITIAL CAMERA CONFIGURATION
Camera cover
screws
Holes for the
mounting screws
Screws on the sides of
the ball camera
