NVIP-2DN5000D/IR-1P, NVIP-3DN5000D/IR-1P, NVIP-5DN5000D/IR-1P User’s manual
(short form) ver.1.1
All rights reserved © AAT Holding sp. z o.o.
9
2.2. Camera mounting
1. Press down on the tab marked with an arrow to lift up the dome cover slightly. While pressing on
tab, twist the dome cover counter clockwise just a few degrees to release dome cover from back clips.
Lift off the cover.
There are three ways to mount camera:
Method 1: Direct Attach Install
2a. Use the included mounting template or the camera to mark holes for
the mounting screws.
3a. Drill holes in marked places.
4a. Use 3 pieces of M3x72 screws to mount the camera directly to the
mounting surface.
Method 2: Camera Base Install
2b. Use the included mounting template to mark holes for the
mounting screws.
3b. Drill holes in marked places.
4b. Remove the camera base by unscrewing the 3 base
locking screws, and turn camera module approx. 5
degrees counterclockwise to detach camera base from
the camera module.
5b. Install the base to the correct holes as indicated on the mount template using the M4x32 screws.
6b. Mount camera base and screw 3 base locking screws.
Method 3:
2c. Cut mounting hole into surface using provided mount cut-out template.
3c. Insert camera into cutout. Make sure that the mounting arms are not
extended.
4c. Turn screwdriver clockwise to move mounting arms down until they
make contact with inner mounting surface.
7. Re-attach the camera cover, until it snaps into place.
START-UP AND INITIAL CAMERA CONFIGURATION
http://www.e-camere.ro/camere-supraveghere-ip/Novus/NVIP-3DN5000D-IR-1P
