NVIP
-
2D
-
6402
-
User
’
s manual (short form) ver 1.0.
All rights reserved © AAT Holding S.A.
10
2.4. Connecting power supply to the camera.
Camera can be supplied using external power supply unit corresponding with the camera parameters or
by using RJ45 network socket and PoE (802.3at Type 1 ) power supply unit.
Information:
Power supply adapter is not included. Please use power adapter with parameters specified in user
’
s
manual.
CAUTION:
Do not use power supplies and POE adapters not compatible with IEEE 802.3af standard!
Damage resulting from the use of improper power supply is not covered under warranty!
In order to provide protection against voltage surges/lightning strikes, usage of appropriate surge
protectors is advised. Any damages resulting from surges are not eligible for service repairs.
2.4. Camera mounting
1.
Remove dome cover by turning it counterclockwise
2.
Put assembly template of the camera to the desired
mounting surface, and mark drilling holes.
3.
Drill mounting, cable and heat removal holes (1) in
previously selected points.
4.
Mount the camera base using included screws on smooth
surface
5.
Adjust the position of the camera module.
6.
Adjust focal length and focus using proper levers.
7.
Put on the camera cover again, by turning it clockwise.
START
-
UP AND INITIAL IP CAMERA CONFIGURATION
12 VDC +
12 VDC
-
Camera 12 VDC power supply
1
