NVIP-2ATM-4401 - User’s manual (short form) ver 1.0
All rights reserved © AAT Holding S.A.
15
ELECTRIC CONNECTORS AND RESTORING FACTORY DEFAULTS
5. ELECTRIC CONNECTORS
5.1. Connecting power supply to the camera.
Camera can be supplied using external power supply unit corresponding with the camera parameters or
by using RJ45 network socket and PoE (802.3af) power supply unit.
Information:
Power supply adapter is not included. Please use power adapter with parameters specified in user’s
manual.
WARNING!
It is forbidden to use –
as the camera power source –
PoE equipment (adapters, etc.) not
compatible with IEEE 802.3af standard (items called
“
passive PoE power supply
”).
Damages that
results from the usage of improper power supply source are not covered by the warranty.
WARNING!
In order to provide protection against voltage surges/lightning strikes, usage of appropriate surge
protectors is advised. Any damages resulting from surges are not eligible for service repairs.
6. RESTORING FACTORY DEFAULTS
6.1. Restoring factory defaults by software (web browser)
Camera allows to reset its settings to the factory values. To restore the camera settings to the default, go
to the
"Load Default"
tab (Remote Setting -> Advanced -> Load Default). Then select options and
functions of the camera whose settings are to be reset and press the
"Save"
button. After about 30
seconds, you can re-connect to the camera (at the current IP address, as long as it was not reset network
settings or on the default IP address).
6.1. Restoring factory defaults by hardware using RESET button
With the RESET button, user can restore the factory settings by pressing it with the small tool
(for example, the end of the paper clip) and holding it for about 10 seconds.
The camera will restart with factory settings.
