NVIP-1DN3000H/IR-1P, NVIP-1DN3020H/IR-1P, NVIP-2DN3000H/IR-1P,
NVIP-2DN3020H/IR-1P - User’s manual (short form) ver 1.0.
All rights reserved © AAT Holding sp. z o.o.
9
2.2.
Cameras mounting
To mount a camera please follow the instructions below:
•
Put the bracket to the wall in a desired mounting place (with cable hole). Taking the bracket’s
base screw holes as a pattern, mark future drilling holes for screws using a punch.
•
Drill holes in accordance with previously done markings and base hole placement.
•
Mount the camera with bracket on the ceiling/wall with three supplied self tapping screws.
•
Loosen nut “A”.
•
Adjust camera position.
•
Adjust zoom and focus (Feature available only for NVIP-1DN3020H/IR-1P and NVIP-
2DN3020H/IR-1P cameras).
•
Tighten nut “A”.
WARNING! Please note that the wall or ceiling must have enough strength to support the IP Camera.
WARNING! In order to obtain declared degree of protection please seal the camera bracket to prevent
water getting inside. Furthermore, when installing the bracket on rough/uneven surfaces, please
additionally seal the junction with appropriate sealing mass. Please pay special attention to any
mounting holes and if they are a loop-through ones, seal them too.
START-UP AND INITIAL CAMERA CONFIGURATION
A
