NVC-CDN3113H/IR, NVC-CDN3112H/IR; NVC-CDN3111H/IR; NVC-CDN3110H/IR
User’s manual ver. 1.0
All rights reserved © AAT Holding sp. z o.o.
8
2.
INSTALLATION
2.1 Mounting the camera
Using the guide pattern attached, please mark the planned drill holes for wall anchors (and
additional drill hole for the cables). Please ensure that the surface chosen for drilling is an
even one.
Drill the mounting (and cable) holes using appropriate drills (when mounting to surfaces
other than concrete ceiling/walls please equip yourself with appropriate screws/anchors)
Put the video and power cables through a cable hole.
Screw the bracket of the camera using appropriate screws.
Adjust the viewing direction/angle of the camera, adjust the sunshield, lock the desired
position using proper screws/stopping rings
Unscrew caps located at the rear of the camera, adjust zoom, focus and iris level (in models
that are equipped in aforementioned features). It is recommended to check focus settings in
infrared illumination and make correction in color mode to have proper focus in both
modes. (NVC-CDN3111H/IR, NVC-CDN3112H/IR, NVC-CDN3113H/IR)
Screw the caps back on.
2.2 Connections
The camera is equipped with a video and power cable finishing with 2 plugs, one for video
output, while the second is the power supply plug. Images below show plug polarization.
The following connecting order should be kept:
connect the video cable to the BNC plug
connect the 12V DC +/-10% power supply to the power plug
ATTENTION
: Prior to connecting the power supply, please make sure that all required
parameters (output voltage, output current and polarization) are correct. Using
improper power supply may cause malfunction or camera damage. In such a
case, warranty is void.
video
power supply
video
ground
+
- (GND)
INSTALLATION
