NVC-401H/IR, NVC-401V/IR
- User’s manual ver. 1.0
All rights reserved © AAT Holding Sp. z o.o.
9
NVC-401V/IR installation
Put mounting drawing paper to the wall or ceiling and mark drill holes.
Drill holes using markings.
Drill additional hole for video and power cables.
Using mounting screws from the package, attach the base of camera to the ceiling/wall
(holding the camera with hand if needed).
Put video and power cables through a base of camera and a previously drilled hole in the wall/
ceiling.
Put the dome cover on the camera (holding the camera with hand if needed).
Put the stopping ring on the dome cover and gently screw it to the base .
Manually point the camera in a desired direction to obtain a desired scene view.
Screw the stopping ring firmly (holding the camera with hand if needed).
4.1 Power supply connection
Warning: Device should be supplied only from a power sources whose parameters are
in accordance with those specified by the producer in the camera technical
datasheet. Therefore, it is forbidden to supply the camera from power sources with
their parameters unknown, unstable or not meeting the producer’s requirements.
See the power supply terminal connections below.
5. SETTINGS
Camera is equipped with an OSD menu. During camera operation, status information can be dis-
played on the screen.
As mentioned before, a joystick is attached to power/video cable, for navigating and changing menu
settings:
INSTALLATION
video
12V DC +/- 10%
video
GND
+
- (GND)
