NVAHD-4DN3202V/IR-1 - User’s manual ver. 1.0
All rights reserved © AAT Holding S.A.
7
INSTALLATION
3.2. Camera mounting
To mount a camera please follow the instructions below:
Remove the decorative ring (A) by turning it counter-clockwise
Loosen the locking screw and remove the lock, remove the camera cover (B), remove the
camera from the base
Put the bracket or mounting template to the wall in a desired mounting place (with cable
hole). Taking the bracket’s base screw holes as a pattern, mark future drilling holes for
screws.
Drill holes in accordance with previously done markings and base hole placement.
Mount the camera base using the supplied plugs and screws.
Connect the camera cables, put camera on the base, attach the cover (B) and pre-tighten the
lock.
Adjust camera position, set appropriate field of view and focus
Tighten to the stop locking screw and install the decorative ring (A) by turning it clockwise.
WARNING!
Please note that the wall or ceiling must have enough strength to support the Camera.
WARNING!
In order to obtain declared degree of protection please seal the camera bracket to prevent water
getting inside. Furthermore, when installing the bracket on rough/uneven surfaces, please
additionally seal the junction with appropriate sealing mass. Please pay special attention to any
mounting holes and if they are a loop-through ones, seal them too.
WARNING!
The declared degree of protection of the camera relates to its housing and does not take into
account the possibility of moisture infiltration into the interior of the camera by connecting
cables. Connection cables protection through i.e. sealing up is the responsibility of the camera
installer. The manufacturer is not liable for any damages to the camera caused as a result of
failing in performing that activity by installer, which also means that camera damaged in that
A
B
A
Zoom
Focus
