NVAHD-2DN5501MV/IR-1 - User’s manual ver. 1.0
All rights reserved © AAT Holding S.A.
7
INSTALLATION
3. INSTALLATION
3.1. Power supply connection
WARNING: Device should be supplied only from a power sources whose parameters are in
accordance with those specified by producer in the camera’s technical datasheet. Therefore, it is
forbidden to supply the camera from power sources whose parameters are unknown, unstable
or not meeting the producer’s requirements.
3.2. Camera mounting
To mount a camera please follow the instructions below:
1.
Unscrew the three screws and remove the camera dome
2.
Taking the bracket’s base screw holes as a pattern, mark future drilling holes for screws.
3.
Drill holes in accordance with previously done markings and base hole placement.
4.
Mount the camera using the supplied plugs and screws.
5.
Connect the camera cables and adjust camera position.
6.
Set-up and fix the camera dome
WARNING!
Please note that the wall or ceiling must have enough strength to support the camera.
WARNING!
In order to obtain declared degree of protection please seal the camera base to prevent water
getting inside. Furthermore, when installing the bracket on rough/uneven surfaces, please
additionally seal the junction with appropriate sealing mass. Please pay special attention to any
mounting holes and if they are a loop-through ones, seal them too.
WARNING!
The declared degree of protection of the camera relates to its housing and does not take into
account the possibility of moisture infiltration into the interior of the camera by connecting
cables. Connection cables protection through i.e. sealing up is the responsibility of the camera
installer. The manufacturer is not liable for any damages to the camera caused as a result of
failing in performing that activity by installer, which also means that camera damaged in that
way is not subject to warranty repairs.
video
12V DC +/- 10% power supply
video
(GND)
+
- (GND)
