Novoterm Kerra Tuluza, Installation Manual

Page: 2 / 25

T ha nk yo u f o r p urc ha s i ng o ur p ro d uc t . Pl e a s e
re a d t hi s ma nua l c a re f ul l y b e f o re c a bi n
i ns t a l l a t io n.
Pictures in this manual are for
information purposes only.
Due to product specificity we recommend installation
of the cabin by authorized installation service. Current
list of authorized service points is available on our
website www.novoterm.pl or at:
801 144 200
NOTE:
If you decide to install the cabin yourself, we would like to advise that due to safety reasons
plumbing and electrical installation of the device must be performed by a qualified plumber or licensed
electrician. Those systems must be executed in compliance with applicable laws and regulations. Incorrect
installation may cause cabin damage!
B E FORE I NS TA L LA TI O N MA KE S URE THA T:
1. 1. The place where the cabin is to be installed
has been prepared as shown on the drawing
(fig. 1).
2.
Water connection is ½’’ and together with the
valves does not stick away from the wall further
than 30 mm.
3. The prepared drain hole is 50mm in diameter and
is adapted to standard rubber reducers available
on the market. The set does not include a reducer.
4. The hot water temperature is not higher than
65°C. Higher water temperature may causa
faster wear of plumbing elements of the cabin.
5. The plumbing system has been flushed and
equipped with angle valves with mechanical
water filters.
6. Static pressure in the water supply system does
not exceed 4.5 bar. For safety reasons
we recommend installation of pressure reducer
regardless of the measurement results
–
temporary pressure fluctuations are possible
even if it is not shown by a measurement.
7.
W e re c o mme nd c o nne c t i ng t he c a b i n t o t he
mu ni c i p a l w a t e r ma i ns , a w a t e r s t o ra g e
he a t e r o r he a t e r w it h e l e c t ro ni c t emp e ra t ure
c o nt ro l . D o n o t c on n e c t t he c ab i n to a
h y d r a ul i c i n s t an t a n eo u s wa t e r h e a t er.
F o r s o me f unc t i o ns s uc h he a t e r ma y no t t ur n
o n o r w a t e r ma y no t re a c h t he t e mp e ra t ure
d e s i re d .
8. Electricity connection or electrical socket are
placed at the height preventing water access or
ensuring that it is resistant to water ingress. The
terminal box or socket must be at least IP45
water resistant. Cabins equipped with grounding
cable must be permanently connected to the
electrical system. Electrical system must be
compliant with PN-EN-60335-1 standard.
9. The supply system is equipped with a 30 mA
residual current circuit breaker with contact
spacing minimum 3 mm.
1 0. The supply voltage is compliant with the
parameters set out on the rating plate and
protection is minimum 1A.
1 1. The room where the cabin is to be installed is
equipped with working and efficient ventilation
system.
1 2. The place of cabin installation has level surface
at even level with the remaining part of the room,
and level vertical walls.
C o mp l i a nc e w i t h t he ab o ve re q ui re me nt s i s ne c e s s a ry f o r c o rre c t i ns ta l l a t i o n a nd us e o f t he ca b i n
tuluza 2.indd 2
2014-09-02 08:36:21
I N ST AL L ATI O N
M AN U AL
H Y D R O M A S S A G E C A B I N
T U LU ZA