Page 6
Replacing the rubber feet by steel spikes
Rubber feet should be used when working on a hard
ground like wooden- or stone floor. This reduces vibra-
tions. In contrast to spikes, which perform very well on soft
grounds like a meadow or sandy floor. To change, turn the
rubber feet counterclockwise out of the leg and screw-in
the spikes clockwise.
Advice:
When mounting make sure that the foot/spike is
well fixed, so that it can not dismount unintentionally. Each
steel spike can be tightened using a wrench and has a hole
for plugging in a lever.
Setting up the leg movement
The force, which is needed to adjust the leg angles can be
set up with a hex key at the tripod shoulder hinge (2). The
key is part of the included Multi-Tool.
2
How to assemble / disassemble a tripod head
In order to connect a tripod head, for example the
Novoflex Classic Ball 5 II, place it centered upon
the upper tripod platform and fix it
from below
with the 3/8“ screw. For this, use the hex key which
is part of the Multi-Tool (included in the scope of
delivery). To secure the tripod head against twist-
ing, it can be fixed in addition with the help of two
small headless screws from below. The fitting hex
key is part of the Multi-Tool.
Advice:
For disassembly do not turn the tripod
head, but loosen all screws from below only. This
prevents ugly scratches at the surface of the plat-
form.
9
TRIO C
C
-PR
O7
5
Page 7
The 75mm half bowl adapter (
TRIO B-
PRO75
, optional accessory) fits into the
upper accessory mount of the TrioPod
PRO75 tripod shoulder. It accepts com-
patible tripod heads with attached 75mm
level half-ball sockets.
The levelling ball
MBAL-PRO75
, (op-
tional accessory) was specifically de-
signed for the TrioPod PRO75. This base
is suitable very well for tasks, when only a
little alignment is needed and this adjust-
ment should be done quick and simple.
For example when a video head, a tele-
photo gimbal head or a panoramic head
should be levelled.
Installing the half bowl adapter TRIO B-PRO75, the levelling ball MBAL-PRO75
or the geared center column TRIO CC-PRO75
The geared center column
TRIO CC-PRO75
, (optional accessory) is
suitable for quick and precise shooting-height adjustment. A time-con-
suming leg length matching is no longer required.
All devices can be inserted into the 70 mm tripod basis mouth and fixed
using three headless screws.
Removing the upper tri-
pod platform
For this, loosen the three
headless screws (5) at about
2/3 of theirs length. Use the
hex key which is part of the
Multi-Tool (included in the
scope of delivery).
After that, pull out the tripod
platform.
5
5
5
MBAL-PRO75
4
3
TRIO B-PRO75
