—5—
A
A1
Aero
®
Press End Plate Removal and Reassembly
Tools to Service Press
• 2 mm hex key
• 6 mm hex key
• 7 mm crescent wrench
• Aero® splice press instruction manual
A2
End Plate Removal to Access Electrical Tray
Both top and bottom press beams contain an electrical tray with all electrical and pneumatic
components. Prior to accessing electrical trays unplug all power cables (power switch alone is not
sufficient). Procedure to remove electrical trays are as follows:
Ü
Top Beam End Plate
Removal To Access
Electrical Tray:
1. Locate rear top end plate (end without display
screen). Using 6 mm hex key, unscrew 3 bolts
located on rear top end plate.
Pull away from extrusion.
2. Disconnect ground wires from end plate.
Remove end plate.
