06/08 Rev. 4.05-01
USER MANUAL
Setting up
TTX
x50/67x
–
Wildcats/Wildcats plus
–
S 45/65/95/105
–
TDI/STDI/XXTREME
13
Installing options
General information
Installation must only be carried out by
trained personnel!
Some options (e.g. the dispensing
module, short tag option) must only be
integrated into a device by technicians
authorized by the manufacturer.
Please note that this is only possible
from a certain serial number of the
device.
Switch the device off and unplug from
the mains before starting servicing work.
Further information about fitting and
setting up options can be obtained from
the relevant manual.
Color option
(not for TTX 350)
The color option is a special case. To be able
to use this option, special firmware must be
transferred to the printer and an additional
sensor must be fitted (see Color Manual).
Short tag option
(TDI/STDI/XXTREME only)
The short tag option ensures that short labels
(from 50 mm) can be processed in the device.
(A tag is a type of label)
The option is an auxiliary feed which is driven
by the feed axle. The label is ejected at the
separating edge, led to the auxiliary feed,
taken over there and finally led to the main
feed.
This option can be retrofitted
(from SN 6800131605).
Fonts
The fonts of the printer are what are known as
proportionally-spaced fonts. For reasons to do
with the standard, only OCR fonts are not
proportionally-spaced fonts.
Proportionally-spaced means that each
character takes up a different width. This
produces a reader-friendly typeface. Fonts
which are not proportionally spaced have the
same width for every character.
