04/13 Rev. 1.12-02
USER / SERVICE MANUAL
Mounting/Setup
LA-TO / LA-TO XL
Settings
24
Valves
Tool
Small screwdriver (0.6x4 mm)
Adjusting the support air
The force of the support air can be adjusted using the
set screw [31A]. For information on the proper setting,
refer to chapter
Adjust the vacuum at the pressure plate
The holding force of the pressure plate can be adjusted
using the set screw [31B]. For information on the proper
setting, refer to chapter
WARNING!
Danger of cuts and crush injuries especially
at the following points:
•
Between moveable vacuum plate and
dispensing edge.
•
Between the guiding rods of the applica-
tor.
•
Between vacuum plate and conveyor
belt, if present.
For this reason pay attention to the following
when triggering the applicator for test or
setup purposes...
keep a sufficient distance.
don´t touch the applicator.
[31] Adjusting the support air and the holding force.
B
A
