Novexx Solutions ALX 92x, Service Manual

Page: 650 / 824

05/16 Rev. 03 USER- / SERVICE MANUAL Info-Printouts & Parameters
AP 5.4 Gen II – AP 5.6 AP 4.4 – AP 5.4 64-xx – DPM – PEM – ALX 92x – ALX 73x (PMA)
128
DP INTERFACE

The parameters described in this section only appear in the parameter
menu after a USI board is mounted.

For information on signals and pin assignment of the USI, refer to the Service
Manual, topic section "Electronics", chapter "USI board".
Interface type
64-xx ALX 92x DPM PEM ALX 73x (PMA)

Only with USI board.
Sets the machine to the used application procedure.
USI interface
Setting for direct dispensing.
USI applicator Setting for operation of an applicator with additional PLC.
Start print mode
64-xx ALX 92x DPM PEM ALX 73x (PMA)

Only with USI board.
Selecting a print mode. Depending on the selected mode, the input signal
START_PRINT will be interpreted differently by the USI interface.
Requirements:
•
SYSTEM PARAMETER
> External signal
= „Singlestart“
•
A printjob was transferred (DATA READY)
•
Printer is switched „Online“
•
No error messages

Start Print Mode replaces the Parameter
SYSTEM PARAMETER
> Signal edge
,
which can be found in older firmware versions.

64-xx: This parameter has priority over
SYSTEM PARAMETER > Signal edge
,
which is relevant for setting the triggering of the single start connector.

Further information about using a start signal: Read the user manual, topic
section „Advanced Applications“, chapter Printing with start signal
 .
Pulse fall/ris
The printing of a label is triggered by a low-high-change as well as by a high-
low-change of the signal at the input START PRINT\. The printing occurs only
after the set delay time.
Level high activ Labels are being printed as long as the signal at input START PRINT is held
high.
Pulse rising
The printing of a label is triggered by a low-high-change of the signal at the
input START PRINT. The printing occurs only after the set delay time.
Level low active Labels are being printed as long as the signal at input START PRINT is held
low.
Pulse falling
(Default setting) The printing of a label is triggered by a high-low-change of
the signal at the input START PRINT. The printing occurs only after the set
delay time.