Novexx Solutions ALX 92x, Service Manual

Page: 50 / 824

07/15 Rev. 01 SERVICE MANUAL Installation / Deinstallation
ALX 92x Installing options
24
Remote operator panel
Important notes
A remote operator panel is necessary, if the machine is
installed at an inaccessible place, where the standard
operator panel can not be reached.

Remote and standard operator panels can be used
alternately.
The machine-side connector [1B] for the operator panel
is an option. If the option was ordered with the machine,
the connector will be ready installed.
For information about retrofitting the connection read
the service manual, topic section
Mechanics  , chapter
„Remote operator panel“.
Connecting
 Plug the operator panel [1A] to connector [1B].
Wall mounting
Tool:
Cross-head screwdriver sizes 3/5
Mounting:
1. Drill 2 holes according to the distances in the draw-
ing [2A].
2. Open the operator panel housing (4 screws).
3. Mount the lower part of the housing to the mounting
surface using 2 M4 screws.
4. Close the operator panel housing.
Dust filter A6206
See service manual, topic section Mechanics

> Housing >
Dust filter (ALX)
WLAN-CF-card A7456
See service manual, topic section Advanced Applications

>
Data transmission with WLAN
CAUTION!
if the connection cable is longer than 2.5 m,
EMC-caused disturbances can occur.
 Only use the factory-installed cable.
 Don´t extend the cable.
Option Article number Installation instructions
[1] Connecting a remote operator panel (A).
[2] Hole distances for wall mounting or the remote operation
panel.
A
B
A
A