Novexx Solutions ALX 92x, Service Manual

Page: 331 / 824

12/14 Rev. 05 SERVICE MANUAL Service Electronics
64-xx Gen. 2 – DPM Gen. 2 – ALX 92x Gen. 2
18
Signal description (CN300)
Pin assignment jumper block
Each signal of the D-Sub connector can be interrupted separately at the jum-
per block.

The voltage and ground wires are through-connected and cannot be interrup-
ted (see
Fig. 4 )!
[4] Pin assignment jumper block
Pin Signal Signal
type Function
1 OD control
material In To be applied to the OD control material option.
The signal WARNING at pin 9 of the DB 15 is switched activ, if
•
Parameter
DP INTERFACE>
Material signal = „On“ a nd
•
the input is high
2 Applicator fault
home position In If one of the inputs is high or makes a low-high-transition, the appropriate status
message is displayed at the printer. Additionally, the outputs ERROR\ and
MACHINE STATUS\ will be activated (low).
3 Applicator fault
touch down In
4 PLC ready /
fault In
5 GND Ground GND potential of the internal inputs
[Tab. 5] Signal designations and functions of the internal inputs
GND
MACHINE STATUS\
REPRINT\
24 V
DATA RDY\
RIBBON OUT\
PAUSE\
MEDIA OUT\
FEED\
PRINT END\
START PRINT\
5 V
GND
WARNING
ERROR\
APPLICATOR MODE