Operating manual ALX 73x | file version 00 | 04/2011
Rubber rollers |
10
C
LEANING
ALX
73x
GB
Pressure roller
1. Switch off the machine.
2. Remove the mains power connecting line.
3. Remove the material and ribbon.
4. Remove the bolt [14B] (using 3 mm Allen key).
5. Remove guide section [14A] from side.
6. If printhead does
not
move into position at far left or
right of printhead axis: Mark position of printhead
on axis.
8. Wipe off the pressure roller [15A] using a lint-free
cloth and roller cleaner (part no. 98925). Rotate the
roller step for step until it is completely clean.
9. Reinstall the guiding section and fasten it with the
bolt.
Push the guiding section with the groove [16A]
over the rear guide tab on the sensor arm [16B].
10. Reinstall the printhead at its former position.
WARNING!
Burn hazard! The printhead can become hot
during operation.
Be careful whenever touching the printer.
[14] Remove the guiding section (A).
[15] Position the pressure roller (A) in the printer (guiding section
and printhead removed).
[16] Guide tab (B) on the sensor arm.
A
B
A
B
A
