01/13 Rev. 5.05-01
USER MANUAL
Attachment, Setup
Rewinder
2000
14
8. Move the bouncer arm up to
the stop plate i the direction
of the support leg, and then
back again by approx. 5 mm.
Press the Enter button.
rewinder adjust
Mind the notes
following this table!
9. Repeatedly press the Prog
button until
OFFLINE 0 JOBS
Set the value approx. 5 mm before reaching the final or zero position,
respectively!
Press the Cut button in the resting position but the Online button in the end
position!
CAUTION! - If programming is interrupted by pressing the Esc-button, the
printer uses preset values which may cause the device to malfunction!
