N'oveen PR450, Instruction Manual

Page: 15 / 26

PR750 OPERATION
a. MP3 playback (applies to PR750)
Set the function switch to MP3 to play USB / SD / MP3:
1). Insert the USB (with MP3 files) or SD card into the USB input or SD card reader to
play songs. During playback, press the Play / Pause button to pause playback, then
press again to resume playback.
2). During playback, press PREV to skip to the previous song; press NEXT to skip to
the next song. Long press these two buttons to fast forward and rewind.
3). When the USB memory and SD card are connected to the device at the same
time, press PLAY / PAUSE button for about 1 second to switch between the USB
input or SD.
4). Bass adjustment: when you listen to music, you can adjust the level of low tones
using this regulator.
5). Repeat tracks: press and hold the REPEAT button to start repeating the whole
folder / repeating one song / canceling the repetition.
6). When you want to stop the playback, set the switch to OFF, disconnect
USB or SD card.
Note: Please do not pull out USB or SD memory during playback, it may cause
damage to the memory storage (applies to PR750).
b. RADIO (applies to PR750)
Set the function switch to FM / MW / SW to listen to the radio:
1. Set the switch to FM and then use the tuning knob to set the desired station in the
88-108 MHz range.
2. Set the switch to SW, then use the tuning knob to set the desired station in the 8-
16 MHz range (on the 18 MHz scale).
When receiving FM, SW, extend the telescopic FM antenna to get the best reception.
3. Set the switch to MW and then use the tuning knob to set the desired station in the
range 530-1600 Khz.
When receiving a MW signal, adjust the position of the radio to get the best
reception.
15