Chapter 2 RELAY7 Installation
RELAY7 User Manual v3
21
Figure 8: SMART7 and RELAY7 Mounting Hole Locations
These mounting holes are intended for attachment to a metal plate. When attaching to a 2.5 mm
to 3 mm thick metal plate, use four M4X0.7 thread X 12 mm length screws that pass through the
plate and into the SMART7 and RELAY7 mounting holes. Torque the screws to 10 - 12 in-lbs.
If using a thicker mounting surface, select screws that penetrate into the mounting holes
6 mm (±1 mm).
2.5 Power Up the RELAY7
Once internal connections between the SMART7 and RELAY7 are complete and the two modules
tightly attached, connect the SMART7 Ampseal interface cable to the back of the RELAY7 (refer
to
on page 40 for cable details). Apply power and check the
front LED on the RELAY7 for status.