Novatel Wireless Inc.
Version 2.0
12/15/2011
4 of 8
1.0 Introduction
This document provides OEM installation requirements for the MC551 device
(FCC ID: PKRNVWMC551S). As the grantee, Novatel Wireless is responsible for all
integrations and must be consulted on all regulatory matters involving the MC551.
The document outlines what RF Exposure considerations are required for OEM
installation using the MC551. If the installation of the MC551 is outside of the
provided guidelines, contact Novatel Wireless for further instructions.
When integrating the MC551 into host devices as described in this document
please contact Novatel Wireless at http://www.nvtl.com/support/index.html. Novatel
Wireless must be notified to ensure that the regulatory guidelines provided in this
document are fully understood and complied to.
2.0 Module Installation Guidelines
This document addresses the following installation host configurations and
conditions:
i)
The MC551 must be installed by OEM as a standalone transmitter in final
products where greater than a 2.4cm (24mm) separation distance is provided
between the MC551 transmitting antenna and the end user. Refer to
Section
3.0 on OEM
Installation Guidelines.
ii)
Collocated transmitters that can operate simultaneously with the
MC551module are only allowed if the requirements defined in the
Section 4.0
Collocated Installation Guidelines
are satisfied.
iii)
If the MC551 is in an enclosure, the FCC and Industry Canada IDs must be
permanently affixed on the exterior of the final product..
iv)
A label must be applied to the outside of the device with the following
wording:
This device contains FCC ID: PKRNVWMC551S
.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
v)
These installation guidelines are not applicable to installations where
the separation distance between the modem and users cannot be
guaranteed to be greater than 2.4cm (24mm).
