Chapter 7 Troubleshooting
OEM7 Installation and Operation User Manual v4
111
Bit Set
Action to Resolve
25-26
None. These bits identify the receiver family. For OEM7 receivers, bit 25 is set to 1 and
bit 26 is set to zero.
27
Interference Toolkit HDR mode status. When this bit is set to 1, Interference Toolkit HDR
mode is enabled.
28
Digital filter status. When this bit is set to 1, an Interference Toolkit digital filter is
enabled.
29
None. This bit indicates if any bits in the auxiliary 3 status word are set. The auxiliary 3
word provides status information and does not contain any new information on problems.
Refer also to the
FRESET
command in the
OEM7 Commands and Logs Reference Manual
30
None. This bit indicates if any bits in the auxiliary 2 status word are set. The auxiliary 2
word provides status information and does not contain any new information on problems.
Refer also to the
FRESET
command in the
OEM7 Commands and Logs Reference Manual
31
None. This bit indicates if any bits in the auxiliary 1 status word are set. The auxiliary 1
word provides status information and does not contain any new information on problems.
Refer also to the
FRESET
command in the
OEM7 Commands and Logs Reference Manual
7.2 Examining the AUX1 Status Word
Table 12: Resolving an Error in the AUX1 Status Word
below provides actions to take when your
receiver has an error flag in the AUX1 status word.
Bit Set
Action to Resolve
0-2
Jammer detected
3
None. This bit indicates that Position Averaging is ON
4-6
Jammer detected
7
Connect the receiver via USB
8-10
Reduce the amount of logging on the USB ports
11
(Reserved bit)
12
None. This bit indicates a Profile set using the
PROFILE
command is activated.
13
Throttled Ethernet Reception
Check for unusually high Ethernet traffic being directed to the Receiver.
This does not represent an error condition on the receiver, but suggests there may be an
issue in the network environment on the receiver.
Table 12: Resolving an Error in the AUX1 Status Word
