Novatel OEM615, Installation And Operation Manual

Page: 141 / 208

OEM617D Technical Specifications Appendix C
OEM6 Family Installation and Operation User Manual Rev 12 141
Figure 69: Top-view, P1101 Main Connector 20-Pin Header
Pin Signal Type Description Comments
1 LNA_PWR PWR Antenna power input
An LDO regulates the output voltage to 5 VDC
±5%. The input voltage should be 6 VDC to 12 VDC
2 3V3 PWR Supply voltage input 3.3 V +5%/-3%
3 USB_D- IO USB data (-)
One-half of a differential pair (pins 3 and 4). Match
lengths and route as a 90
Ω differential pair if USB
is required
4
USB_D+ /
RXD3
a
IO
USB data (+) / COM3
receive data
One-half of a differential pair (pins 3 and 4). Match
lengths and route as a 90
Ω differential pair if USB
is required
This pin is internally multiplexed. See
Connecting
Data Communications Equipment on page 38.
5 RESETIN I Reset input Active low reset
6
USERVARF /
CAN1RX
IO
Variable frequency output
/ CAN1 receive data
These pins are internally multiplexed. See
Connecting Data Communications Equipment on
page 38
7
EVENT2 /
CAN1TX
IO
Event 2 Input / CAN1
transmit data
8 CAN2RX I CAN2 receive data
9
EVENT1 /
TXD3
a
IO
Event1 input / COM3
transmit data This pin is internally multiplexed. See Connecting
Data Communications Equipment on page 38.
10 GND PWR Signal and power ground
11 TXD1 O COM1 transmit data
12 RXD1 I COM1 receive data
13 GND PWR Signal and power ground
14 TXD2 O COM2 transmit data
15 RXD2 I COM2 receive data
16 GND PWR Signal and power ground
17 PV O Position valid indicator Active high output
18 GND PWR Signal and power ground
19
PPS
b
O
Timemark output,
synchronous to GPS time This pin has an internal 50 ohm line driver. Route
as a 50
Ω single-ended trace
20 CAN2TX O CAN2 transmit data
a. The COM3 UART can be configured with firmware on pins 4 and 9.
b. The terms TIMEMARK and PPS are synonymous.