Commands
Chapter 5
EuroPak-15ab Receiver User Manual Rev 1
53
5.3.4
CHANCONFIG
This command changes the channel configuration of the receiver. This will effect the number of channels
tracking GPS signals, Galileo signals, and GEO signals. Entering this command will reset the receiver, causing
the receiver to initiate a cold-start bootup and reset all data stored in NVM to factory default values (except for
the channel configuration).
The default configuration of the EuroPak-15ab receiver is 24GALILEO8GPS.
Syntax:
Message ID: 501
Example:
CHANCONFIG 16GPSL1L5
Table 18: Configuration
Values
CHANCONFIG
CONFIG
Field
Field
Name
Valid Values
Description
Format
Binary
Bytes
Binary
Offset
1
header
This field contains the
Abbreviated ASCII
command name. See
Section 4.1
on
Page 34
.
H
0
2
config
See
Table 18
below.
Specifies the channel
configuration for the receiver
to use.
Enum
4
H
ASCII
Description
16GPSL1L5
8 GPS L1 + 8 GPS L5 channels
10GALILEO6GPS
5 Galileo L1 + 5 Galileo E5a + 6 GPS L1 channels
16GALILEOL1E5a
8 Galileo L1 + 8 Galileo E5a channels
8GPS8GEO
8 GPS L1 + 4 GEO L1 + 4 GEO L5 channels
12GPS4GEOL1L5
6 GPS L1 + 6 GPS L5 + 2 GEO L1 + 2 GEO L5 channels
24GALILEO8GPS
a
a. There are channels in the 24GALILEO8GPS configuration that can track the
GIOVE-A test satellite, see
Table 59
on
Page 125
.
8 GPS L1 + 8 GAL L1 + 8 GAL E5A + 8 GAL E5B channels