Novatel EuroPak-15ab, User Manual, Page: 47 / 134

Commands Chapter 5
EuroPak-15ab Receiver User Manual Rev 1 47
5.2 Command Summary
Table 14: Command Summary
Command Name
Message
ID
Description Syntax
AGCMODE
229
Control Automatic Gain Control (AGC)
agcmode frequency mode
[pulsewidth loadvalue]
ANTENNAPOWER 98
Control power to low-noise amplifier of
an active antenna
antennapower flag
ASSIGN 27 Assign individual satellite channel to a PRN
assign channel [state] [prn
[Doppler window]]
CHANCONFIG
501
Set receiver channel tracking configuration chanconfig config
COM 4 Serial port configuration control
com [port] bps [parity
[databits [stopbits
[handshake [echo [break]]]]]]
ECUTOFF
50
Set satellite elevation cutoffs ecutoff angle
EXTERNALCLOCK
230
Set external clock parameters
externalclock clocktype
[freq] [h0 [h1 [h2]]]
FIX
44
Fix height, position or velocity fix type [lat lon height]
FRESET 20
Clear data stored in non-volatile memory.
Followed by a receiver reset.
freset
LOG 1 Request logs from receiver
log [port] message [trigger]
[period [offset] [hold]]
POSITIONTYPE
836
Set position filter to GPS L1 or L5
frequency
positiontype frequency
PULSEBLANKING
519
Enables or disables digital pulse blanking
for L1 or E5a/E5b signals. pulseblanking frequency
switch
RESET
18
Perform a hardware reset reset [delay]
SDLLBW
800
Configure channel’s DLL filter bandwidth sdllbw dsigchan bw
SPLLBW 801 Configure channel’s phase-lock-loop bw spllbw psigchan bw
STHRESHOLD
803
Control signal channel thresholds for
acquisition, tracking and cross correlation sthreshold sigchan acqui
lock crosscorr
UNLOG
36
Remove log from logging control unlog [port] datatype
UNLOGALL 38 Remove all logs from logging control unlogall [port]