28
FIBER_TIGER_manual, 2021-11-29
NOTICE
Contaminated or damaged fiber tip
damages the fiber and/or the laser.
a) Ensure that fiber coupling and fiber tip are clean. If necessary clean the
fiber coupling and the fiber tip.
b) Ensure the fiber tip is undamaged. If necessary replace the fiber.
c) Pay attention to the fiber’s minimal bending radius.
4.3.
Installing
4. Preparing for use
Requirements
Table 4.7.: Laser beam supply
Characteristic Specification
Laser
standard industrial fiber laser in single- or multi-mode
Wavelength 1030 to 1080 nm
max. power
3 kW at 100 % duty cycle with single-mode fiber
8 kW at 50 % duty cycle with multi-mode fiber
Fiber type
Single- or multi-mode fiber with standard industrial connector
system
Procedure
1. Remove the protective cover from the laser beam exit of the scan head.
2. Keep the protective cover and the screws for future use.
3. Remove the protective caps from fiber coupling at the scan head and from the fiber
tip of the laser fiber.
4. Keep the protective caps for future use.
5. Align the fiber tip with help of the red dots to the fiber coupling.
6. Insert the fiber tip as far as it will go into the fiber coupling.
7. Turn the bayonet ring in direction 1; see figure 4.14 on page 29.
