MicroE Optira Installation Manual
Celera Motion
IM-1001 | REV181211
Page 1
©2018 Celera Motion
2.0 Introduction
2.1 Overview
The instructions in this manual apply to the following Optira Series Encoders models:
•
Model PIA Standard 5 V
•
Model PIB Standard 3.3 V
2.2 Precautions
1.
Follow standard ESD precautions. Turn
power to
off
before connecting sensor.
2.
Do not touch
electrical pins without static protection such as a grounded wrist
strap.
2.3 Laser Safety Information
This product is sold solely for use as a component (or replacement) in an electronic product;
therefore, it is not required to, and does not comply with U.S. FDA
21 CFR 1040.10
and
1040.11
which pertain to complete laser products. The manufacturer of the complete system-level
electronic product is responsible for complying with 21 CFR.
MicroE Systems encoders contain an infrared laser diode or diodes. Emitted invisible laser
radiation levels have been measured to be within the
CDRH Class 1
range, which is not
considered hazardous; however, to minimize exposure to the diverging beam, install the
encoder
sensor in its operational configuration in close proximity to the encoder scale before
applying power
.
•
Invisible laser radiation; wavelength: 850 nm.
•
Maximum power of 4.8 mW CW for Optira.
•
Caution
: The use of optical instruments with this product will increase eye hazard.
Do
not
view directly with optical instruments (microscopes, eye loupes, or magnifiers).
•
All maintenance procedures such as cleaning must be performed with the MicroE
encoder turned
off
.
•
Do not
insert any reflective surface into the beam path when the encoder is powered.
•
Do not
attempt to service the MicroE encoder.
