7.0 EMC COMPLIANCE
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the
limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment
is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual,
may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to
cause harmful interference in which case the user will be
required to correct the interference at his own expense.
This ISM device complies with Canadian ICES-001.
Cet appareil ISM est conforme à Ia norme NMB-001 du Canada.
EN55011/CISPR 11, Group 1, Class B device.
Class B equipment is suitable for use in domestic establishments
and in establishments directly connected to a low voltage power
supply network which supplies buildings used for domestic
purposes.
8.0 CE COMPLIANCE
This product has been tested and complies with European
CE requirements for the EMC Directive. Please note that
shielded cable must be used.
1200 BAUD
EXAMPLE:
900 ohms max load resistor = ( 24 V - 6 ) / 0.02A
supply
( V
- 6 )
0.02
load resistor (ohms) =
out
Maximum I
SET LOWER JUMPER PAIR
TO RS-485 OR RS-232
9600 BAUD
16 SAMPLE AVERAGE COUNT
1.8 HZ
WIRING CONFIGURATIONS
