NOVAK ELECTRONICS • PROFILE SOFTWARE
15
UPLOADING PARAMETERS FROM CYCLONE
The following steps will allow you to upload the Parameters from
the Cyclone speed control. The values for the Profile (1, 2, 3, or 4)
that is currently active in the Cyclone will be uploaded.
1.
With DataLink connected as previously instructed, turn on the
DataLink’s power switch. Red power LED will blink on and off.
Note: We recommend that you turn off the DataLink’s power when
not in use to extend the life of the 9V battery.
2.
Start your computer and Run the Profile Software program as
previously instructed.
3.
Turn on your transmitter, then turn on your speed control.
Note: Use a DSC cord to disable the transmitter’s RF section to avoid
radio interference. If you do not have your transmitter or a DCS cord,
disconnect the servo from receiver and lift the vehicle’s wheels into the
air until D•LINK is connected.
Note: Motor will be disabled as soon as D•LINK harness is connected.
4.
Connect the DataLink’s D•LINK harness to your Cyclone’s
DataLink socket located on the top of the speed control. The
D•LINK connector can only clear the transistors on the speed
control if the “D•LINK” lettering is right side up. If you have
external heat sinks installed, be sure that they do not extend
beyond the front edge of the transistors––You may need to
reposition heat sinks to gain proper access to the connector.
At this time the Cyclone’s LED should be illuminated solid red.
5.
From the main menu, use the up {
↑
} or down {
↓
} arrow keys
to highlight “Upload Parameters From Cyclone”, then press
{Enter} or {Return} to select.
6.
Press {Enter} or {Return} to upload the parameters from the
Cyclone.
7.
Press {Enter} or {Return} again to return to the main menu.
