Unbolt the light brackets from
their storage positions.
(Figure 4) You will not re-use
the nut from the light bracket
but you will need the bolt.
Insert the tab into the slot on
the trailer side frame (Figure
5) and slide the bracket to the
rear to fully engage the tab.
Install the bolt you removed
from the light bracket. The
bolt will tighten into the rivet-
nut that is in the side of the
trailer. Insert the grommet
into the frame hole to protect
the wire going through the
side frame. Feed the excess
wire through the bolt hole
that the light bracket was
stored in and insert the
grommet to protect the
folded over wire. (Figure 6)
Repeat this process for the
other tail light.
Figure 4
Figure 5
Figure 6
3
