
21
TABLE ALIGNMENT ADJUSTMENT
Over time, the Mitre Saw angles may
require adjusting so that the 0° angles (both
bevel and mitre) are located at exactly 0°.
1. Ensure the plug is disconnected from the
power supply.
2. Push the cutting head down to the lowest
position and engage the head locking pin.
The Mitre Saw should now be secured in
the transport position.
3. Locate the screw at the front of the mitre
angle indicator (Fig. 34).
4. Loosen or tighten the screw as required
to adjust the angle until the correct
alignment is achieved.
5. Use a set square to (not included) to
check the alignment of the mitre table.
6. Using a scrap piece of wood, perform a
straight cut at 0°.
7. Use a set square to check that the cut is
Adjustment screw
Adjustment
nut
BLADE ALIGNMENT ADJUSTMENT
After replacing the blade or over time, the
Mitre Saw angles may require adjusting so
that the 0° angles (both bevel and mitre)
are located at exactly 0°.
1. Ensure the plug is disconnected from the
power supply.
2. Push the cutting head down to the lowest
position and engage the head locking pin.
The Mitre Saw should now be secured in
the transport position.
3. Locate the two nuts at the back on either
side of the body (Fig. 33).
4. Loosen or tighten a screw as required
to adjust the angle. Repeat this process on
the opposite side, tightening or loosening
until the correct alignment is achieved.
5. Use a set square (not included) to check
the alignment of the blade.
6. Using a scrap piece of wood, perform a
straight cut at 0°.
7. Use a set square to check that the cut is
accurate.
8. If the cut is not square, repeat steps 1-7
to set the blade square.
Fig.33
Fig.34
Summary of Contents for NG-250
Page 24: ...www spoton com au...