Nouveau ND60SS, User Manual

Page: 20 / 22

The dishes were not
loaded correctly. See notes in " Loading the Dishwasher Baskets ".
Select a more intensive program.
See" Wash Cycle Table .
"
Use more detergent, or change your detergent.
Rearrange the items so that the sp ay arm can rotate
freely. r
Clean and/or fit the filter correctly.
Clean the sp ay arm jets. See "Cleaning the Spray
Arms". r
assembly
Use less detergent if you have soft water and select
a shortest cycle to wash the glassware and to get
them clean.
Use a mild abrasive cleaner to eliminate those marks.
Reload the dishwasher such that the detergent
dispenser is not prevented from opening during
the wash cycle.
Load the dishwasher as shown in this user manual.
Increase the amount of rinse-aid/refill the rinse-aid
dispenser.
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only once
the dishes are barely warm to the touch. Empty the low
basket first. This prevents water form dropping off
dishes in the upper basket.
In short programs the washing temperature is lower.
This lowers cleaning performance. Choose
a program with a long washing time.
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
The program was
not powerful enough.
Not enough detergent
was dispensed.
Items are blocking
the path of sp ay arms.
r
The filter
in the base of
is not
clean or is not correctly
fitted. This may cause
the sp ay arm jets
to get blocked.
r
assembly
the
dishwasher
Combination of soft
water and too much
detergent.
Aluminum utensils
have rubbed against
dishes.
Dishes block
detergent cups.
Improper loading
Too little rinse-aid
Dishes are removed
too soon
Wrong program
has been selected
Use of cutlery with
a low-quality coating
17
Unsatis
-factory
washing
result
Unsatis
-factory
drying
result
If overflow occurs, turn off the main water supply before calling a service.
If there is water in the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher.
In the event of a malfunction, the control panel may show a particular combination of lights to indicate an error code.
The following table describes these error codes.
Overflow.
Water supply too slow.
Faucets is not opened, or water intake is restricted,
or water pressure is too low.
Some part of the dishwasher may be leaking.