The control panel can be cleaned by using a lightly dampened cloth.
After cleaning, make sure to dry it thoroughly.
The exterior should be cleaned with a gentle cloth soaked in warm soapy water, and dried thorougly.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.
Protect Against Freezing
1.Cut off the electrical power to the dishwasher.
2.Turn off the water supply and disconnect the water inlet pipe from the water valve.
3.Drain the water from the inlet pipe and water valve. (Use a pan to catch the water)
4.Reconnect the water inlet pipe to the water valve.
5.Remove the filter at the bottom of the tub and use a sponge to soak up water in the sump.
In colder climates, it may be necessary to
completing a wash cycle, please do the following:
take frost protection measures on the dishwasher in winter. Every time
- Inspect the filters for blocking after every time the dishwasher has been used.
- By unscrewing the coarse filter, you can remove the filter system. Remove any food remnants and
clean the filters under running water.
Remarks:
Cleaning the Filter
Cleaning The Door
To clean the coarse filter and the fine filter, use a cleaning brush. Reassemble the filter parts as shown in the figures
on the last page and reinsert the entire assembly in the dishwasher, positioning it in its seat and pressing downwards.
The entire filter assembly should be cleaned at least once a week.
When cleaning the filters,
.
Otherwise, the filters could be contorted and the performance of the dishwasher could
be decreased.
be careful not to damage them by using excessive force
To clean the edge around the door, you should use only a soft warm, damp cloth.
To avoid penetration of water into the door lock and electrical components, do not
use a spray cleaner of any kind.
Never use a spray cleaner to clean the door panel as it may damage the door lock
and electrical components.
Abrasive agents or some paper towels should not be used because of the risk of
scratching or leaving spots on the stainless steel surface.
Cleaning the Spray Arms
12
If your dishwasher
because of
, please
professional
service person.
will not function
ice formation
contact a
It is necessary to clean the spray arms regularly as hard
water chemicals may clog the spray arm jets and bearings.
To remove the spray arms, screw off the nut clockwise to
take out the washer on top of the spray arm and remove the
arm.
Wash the arms in soapy and warm water and use a soft
brush to clean the jets.
Replace them after rinsing them thoroughly.
Summary of Contents for ND60SS
Page 1: ......
