N-COM Setup manual
18
6
NCOM Application
To be able to make the settings in the monitor, the NCOM app needs to be installed on a Windows PC. Depending on the release
version the filename is:
Nottrot_NCOMx_xx_Installer.msi (where x_xx = version)
Double click to install. After installation please start the application from the Windows start-menu: Nottrot -
NCOM V2.12
, of
coarse depending on the release version.
After starting the NCOM-app the main screen appears.
➔
Do not make any changes without sufficient knowledge
Group listing. Refer to next sections for detailed description:
1-
System network : Make connection to the monitors
2-
ID list
: What is connected (in the daisy chain)
3-
Read, write
: Read/write the parameters from the selected (2) monitor
4-
Tab’s
: Select configuration for monitor settings
5-
Unit ID/state
: ID and status of selected monitor (double monitor from ID-list (2) click to refresh)
6-
LinBus module : Select the controls, corresoding ID and assign push functions
7-
Backlit settings : Backlit behaviour for the controls
8-
Dimming sources : List of dimming sources the selected (2) monitor. Unit refers to Units number (in-external)
9-
Curves
: Select Backlight-TAB to set the curve. Pick the dots and move them.
10-
Backlight settings: Set backlight limits and control parameters
11-
Misc. funcitons : Power control settings for backlight, touch and external control
Summary of Contents for N-COM
Page 26: ...N COM Setup manual 26 ...
