AFP-300/AFP-400 Programming PN 50259:C1 06/19/97
21
6WDWXV&KDQJH
2YHUYLHZ
1RWH $VVLJQ WKH 6WDWXV &KDQJH
SDVVZRUG WR SHUVRQV ZKR GR
QRW QHHG WR GR DSSOLFDWLRQ
SURJUDPPLQJ RU
DXWRSURJUDPPLQJ
Status Change provides a second programming level—accessed by an assigned
password—for changing operating parameters. (These operating parameters do not
affect control program settings.) For example, the Status Change password lets
someone change settings such as detector sensitivity, system time and date, and so on.
From the Password Entry screen (Figure 3), enter the Status Change password to
display the Status Change screen:
)LJXUH 6WDWXV &KDQJH 6FUHHQ
'LVDEOH(QDEOH
1RWH 7KH SURJUDP GRHV QRW DOO
'LVDEOH(QDEOH FKDQJH WR D
LQLWLDWLQJ GHYLFHV LQ DODUP DQG
E FRQWURO SRLQWV WKDW DUH RQ
The Disable/Enable option lets you disable programmed points for detectors, modules,
and NAC/Panel Output Circuit modules.
1.
Select <1> from the Status Change screen to display the Disable/Enable screen:
2.
Select the point type:
+
for detectors
,
for modules
-
for output circuits
]
for zones
The cursor will blink the first SLC address digit in the detector, zone, module, or
output circuit field.
&DXWLRQ 'LVDEOLQJ D ]RQH GLVDEOHV DOO LQSXW DQG RXWSXW GHYLFHV DVVRFLDWHG ZLWK WKH
]RQH
3.
Enter the address of the point, then press <Enter>. A sample display follows:
)LJXUH (QDEOH'LVDEOH 6FUHHQ
You can disable or enable a point by changing the status banner as follows:
Table 20 Enabling or Disabling a Point
67$786 &+$1*( 35(66 ',6$%/ 6(16,7,9
&/5 9(5 &/5 +,67 7,0( :$/. 7(67
To...
Press...
change the status
/
or
0
save the status
&
go to the next or previous point
address
/
or
0
:KHQ \RX GLVDEOH D SRLQW DQG SUHVV (VF! WR UHWXUQ WR WKH 'LVDEOH(QDEOH VFUHHQ WKH FRQWURO
SDQHO D WXUQV RQ WKH 'LVDEOH 3RLQWV /(' E VRXQGV WKH SDQHO VRXQGHU DQG F FKDQJHV WKH
VWDWXV EDQQHU WR 7528%/
%OLQNLQJ VWDWXV EDQQHU (1$%/( RU ',6$%/
(1$%/( 021,725
02'8/( $''5(66
= = = = =
0
