Page of 5
2
Thank you very much for choosing a NORTHERN TOOL + EQUIPMENT CO., INC. Product! For
future reference, please complete the owner’s record below:
Model: _______________ Purchase Date: _______________
Save the receipt, warranty and these instructions. It is important that you read the entire manual
to become familiar with this product before you begin using it.
This machine is designed for certain applications only. Northern Tool + Equipment cannot be
responsible for issues arising from modification. We strongly recommend this machine is not
modified and/or used for any application other than that for which it was designed. If you have
any questions relative to a particular application, DO NOT use the machine until you have first
contacted Northern Tool + Equipment to determine if it can or should be performed on the
product.
For technical questions please call
1-800-222-5381
.
SAFETY INSTRUCTIONS
These units should be placed on a level surface. Failure to do so can result in poor product
performance or create a possible safety hazard. This unit should be securely anchored to a wall or
floor with suitable fasteners, which are included. Do not use this unit for anything other than the
manufactures intended purpose.
DO NOT STAND ON ANY PART OF THE UNIT, OR USE IT AS A
LADDER
. Evenly distribute the weight on each level and always keep the heavier loads on the
bottom. Use care when working with metal parts. Do not exceed the maximum capacity of 300 lbs.
for each shelf. Keep children away; do not allow them to play with or crawl/climb on unit.
GENERAL INSTRUCTIONS
Assembly is done with the rivets of the beams and braces fitting into the slots of the post. A rubber
mallet may be used on the beams and braces to seat the rivets properly. A hammer can also be
used providing one uses a cloth or a block of wood between the hammer head and the parts to
prevent damage. Tap gently and be sure the rivets are straight and fully engaged. Periodically
inspect the general condition of the rack for loose frame connections, undistributed loads, shelving
deformations and any other conditions that may affect the rack’s stability and performance.
ASSEMBLY
INSTRUCTION
Required Tools (Rubber Mallet)
Step 1: (Note: Post are directional. The slot must point down.)
Assemble two (2) posts with one (1) brace. Skipping one slot from the bottom of the post (see
figures A), Place the rivets into post with the slot pointing down, and with the shelf ledge of the
brace facing up (see figures B). Tap lightly to seat rivets. Repeat with two (2) posts and one (1)
brace. Assemble the two (2) posts end units with two (2) beams (see figures C). Skip one hole
from the bottom of post, tap lightly to seat rivets.
