BASIC OPERATION
1.
Fill the unit with water. Ensure there are no leaks
before plugging the unit in.
2.
Plug the boiler into a GFCI outlet.
3.
Make sure the Wattage switch
is set properly.
- Heating Boil 1600W
- Steeping/Mash 600W
4.
Turn on the Main Power Switch
5.
Press the ON/OFF switch on
the Digital Controller
6.
Use the + or - buttons to
set the temp to desired
temperature. The temp will lock
after 5 seconds.
7.
The unit will now heat to the set temperature.
Note:
If you need to change the temperature at anytime
during operation press the SET button to access the menu.
BREW DAY USE
1.
Fill the unit with 3 gallons of water for a partial boil
extract batch
If not steeping grains, you can skip steps 2-4
2.
Flip switch for 1600W & set temp to
desired temp for steeping
3.
Once steeping temp reached, place
grains in the supplied muslin bag and
steep in boiler & switch
to 600W.
4.
After 15 minutes, remove your
grains in the bag.
5.
Flip switch to 1600W & press SET again and adjust
the temp up to 218˚F.
6.
When adding extract, switch the power
off while adding the malt extract to
prevent it from scorching. Thoroughly
stir in the extract and resume boiling.
7.
Boil wort for 1 hr or according to the
instructions for your specific recipe kit.
8.
Once you boil is completed, insert an
immersion chiller into the wort and
chill as normal.
DO NOT SUBMERGE
BOILER IN ICE BATH TO CHILL THE
WORT.
9.
Drain the chilled wort into your sanitized fermenter
through the valve. Top up to 5 gallons with cool,
clean water.
ADDITIONAL OPTIONAL FUNCTIONALITY
DELAY
After setting Run Time, the screen will flash 0:00 for the
TIMER. If you press SET now, the unit will begin heating
right away. You can use this TIMER to set a delay before
the unit turns on. If you wish to do this, simply press + or
- to the desired delay time, then press SET.
MAX RUN TIME
Press SET once more. The default run time of 3 hrs and
30 min. flashes. This is a safety feature to keep the boiler
from boiling off all of the liquid and running dry, which
will ruin the element.
CLEAN UP & STORAGE
Clean the boiler with PBW or similar cleaner, rinse, drain upside-down.
ERROR CODES
ER3 & ER4
Run Dry Protection/Thermostat protection.
Unplug the unit, press the reset button on the bottom
of the boiler, and fill with water. You can now plug the
boiler back in and resume use.
ER5
Temp too high. Unplug and allow unit to cool before
pressing the reset on the bottom.
For all other error codes, please contact customer service.