E
N
G
LI
S
H
6
PARTS & ASSEMBLY
Read assembly instructions carefully before installing the KEGORATOR™. If still
unsure whether the KEGORATOR™ has been properly installed after assembly
is complete, it is recommended that you contact a qualified installer.
Allow the KEGORATOR™ to stand in an upright position for about 8 hours before turning on
the power. Once the unit is laid on its side, the coolant in the refrigeration unit is shifted.
The coolant in the refrigeration unit needs to stabilize before the power is turned on.
WASHERS
Most washers are already attached to the KEGORATOR™. Extra washers are
included and are in a plastic bag. They are labeled below. Refer to parts
diagram and corresponding numbers to see where the washers belong.
#1 Bottom of
#1 Bottom of
#1 Bottom
Coupler (outside)
Coupler (middle)
of Coupler (center)
(38mm)
(22mm)
(19mm)
#3 Coupler Washer
#4 CO2 Rubber
#18 CO2 Tank Band
(18mm)
Directional Washer
#19 CO2 Line to
#21 CO2 Line
#25 Beer Tap
Regulator
to Coupler (10mm)
Washer (22mm)
(7mm)
Summary of Contents for KRS2100 SERIES
Page 2: ...KRS2100 SERIES Kegorator Instruction Manual Manuel d instruction Manual de instrucciones...
Page 3: ......
Page 49: ......
