12
5.4 Master Stage 2
Operates the same as “Master Stage 1” above except this operates a second stage. Be aware that you can use input 1 to trigger both
stages and delay Stage 2 using the “Delay” time. This eliminates the need for any separate delay timers.
5.5 Master GPO
Figure 13 Master GPO
GPO = General Purpose Outputs
GPO’s are low current ground outputs (1 Amp max) that the user programs to occur based on selectable variable. They can trigger items
such as ignition retards, water injection, etc. If the device is over 1 Amp, use the GPO to trigger a relay. If you need a +12v trigger, use
this ground output to activate a relay with a +12v output.
To have an output occur when a particular stage of nitrous is activated, select “Turn on based on nitrous %”. If you select 0%, it will
activate as soon as the nitrous is triggered. Setting it to a higher percent will delay activation of that GPO until that nitrous percentage is
met.
5.6 Monitor Screen
The monitor screen (below) is
opened by clicking on the “monitor” tab. When the controller is powered, you can see (if connected) Engine
RPM (view this to make sure you have the proper RPM Multiplier selected), Input Trigger information, wide band A/F, nitrous pressure,
MAP reading, and monitor the status of all nitrous stages. You can watch them operate on the slide bar.
Figure 14 Monitor Screen
