Norton CST 100 Modulo, Operating Instructions Manual

Page: 16 / 24

16
5.3 General advice for the cutting
•
Material weighting under 30 kg and having dimensions smaller than 650x660x220mm for the
CST65, 850x660x220mm for the CST85, 1000x660x220mm for the CST100 can be cut with the
machine.
•
Before commencing work make sure tools are firmly seated!
•
Select the right tools as recommended by the manufacturer depending on the material to be
worked, the working procedure (dry or wet cut) to be carried out and the required efficiency.
•
Apply cooling water continuously whilst cutting and in good time! Make sure the water pan
contains enough water.
•
When dry cutting, ensure sufficient dust extraction and wear a dusk protection mask!
•
When cutting work is finished, switch the water pump off so you can remove the cut pieces from
the conveyor cart without getting wet.
If the thermal protection trips, allow the thermal protection to cool down. Wait a few minutes to allow
the motor to cool down before restarting the machine.