Norton clipper CMR 351, Operating Instructions Manual

Page: 11 / 20

11
•
Remove the outer flange.
•
Clean the flanges and blade shaft and inspect for wear.
•
Mount the blade on the shaft ensuring that direction of rotation is correct. Wrong direction of
rotation blunts the blade quickly.
•
Replace outer blade flange.
•
Tighten hexagonal nut with spanner supplied for this purpose.
•
Shut retractable blade guard cover and tighten the screw on the front side of the guard.
The blade bore must correspond exactly to the diameter of the blade shaft. Cracked or damaged
bore is dangerous for the operator and for the machine.
3.3 Electrical connections
Check that,
•
the voltage/phase supply corresponds to the information indicated on the motor plate.
•
Available power supply must have ground connection in conformity with safety regulations.
•
The connecting cables should have at least a 2.5mm
2
-section per phase.
3.4 Starting the machine
Open the switch cover and press the green button to start the machine. To stop either use the red
button or press directly on the switch front cover.
3.5 Water cooling system
•
Fill the water pan with clean water to approximately 1cm from top (ensure that bottom of pump is
fully immersed in water).
•
Open water-tap at blade guard (note that handle on water-tap should be in line with water-flow).
•
Ensure that water is flowing freely in the circuit and is delivered adequately to both sides of the
blade, as insufficient water supply may result in premature failure of the diamond blade.
•
The water pump must never run without water. Always make sure that there is enough water in
the pan and refill if necessary.
•
In case of frost, empty the water cooling system from its water.